column 7 of the hazardous materials table

See UN1210, UN1263, UN1266, UN3066, UN3469, and UN3470. The in-page Table of Contents is available only when multiple sections are being viewed. 111 Explosive substances of Division 1.1 Compatibility Group A (1.1A) are forbidden for transportation if dry or not desensitized, unless incorporated in a device. Packaging Authorizations (Column 8) b. 45 Temperature should be maintained between 18 C (64.4 F) and 40 C (104 F). Furthermore, lithium batteries installed in a cargo transport unit, designed only to provide power external to the transport unit must be described using the proper shipping name Lithium batteries installed in cargo transport unit found in the 172.101 Hazardous Materials Table. W8 Vessel stowage category for pyrophoric thorium metal or pyrophoric uranium metal is D as defined in 172.101(k)(4). 175 This substance must be stabilized when in concentrations of not more than 99%. result, it may not include the most recent changes applied to the CFR. The packing group assignment and packaging must be approved by the Associate Administrator for Hazardous Materials Safety on the basis of the criteria in 173.21 of this subchapter and the package type used for the Series 6(c) test. 131 This material may not be offered for transportation unless approved by the Associate Administrator. The packaging may not be loaded with a material outside of the packaging's design temperature range. For vessel transport, the palletized loads, pallet boxes or unit load devices must be firmly packed and secured in closed cargo transport units; or. Use the above summary to assist you in reviewing the special provisions applicable to the HazMat you offer for transportation. 8 A hazardous substance that is not a hazardous waste may be shipped under the shipping description Other regulated substances, liquid or solid, n.o.s., as appropriate. 113 The sample must be given a tentative approval by an agency or laboratory in accordance with 173.56 of this subchapter. 163 Substances must satisfactorily pass Test Series 8 of the UN Manual of Tests and Criteria, Part I, Section 18 (IBR, see 171.7 of this subchapter). The table follows: [Portable tank codes T1-T22 apply to liquid and solid hazardous materials of Classes 3 through 9 which are transported in portable tanks.]. Table 1. The toy plastic or paper caps must be in the form of sheets, strips, rolls, or individual caps; b. An important, but often overlooked, requirement for the safe and regulatory compliant transportation of a HazMat is an understanding of the special provisions in column 7 of the Hazardous Materials Table. 28 The dihydrated sodium salt of dichloroisocyanuric acid does not meet the criteria for inclusion in Division 5.1 (Oxidizer) and is not subject to the requirements of this subchapter unless meeting the criteria for inclusion in another class or division. N45 Copper cartridges are authorized as inner packagings if the hazardous material is not in dispersion. 15, 1976, unless otherwise noted. 128 Regardless of the provisions of 172.101(c)(12), aluminum smelting by-products and aluminum remelting by-products described under this entry, meeting the definition of Class 8, Packing Group II and III may be classed as a Division 4.3 material and transported under this entry. N89 When steel UN pressure receptacles are used, only those bearing the H mark are authorized. The adsorbent or absorbent material shall not meet the definition or criteria for inclusion in Classes 1 to 8; c. The maximum contents of a receptacle shall be 10 kg of ammonia; and. For UN identification numbers 3531, 3532, 3533, and 3534, IBCs must be designed and constructed to permit the release of gas or vapor to prevent a build-up of pressure that could rupture the IBCs in the event of loss of stabilization. Samples taken at random must withstand the prescribed tests without breakage or leakage. 48 Mixtures of solids that are not subject to this subchapter and toxic liquids may be transported under this entry without first applying the classification criteria of Division 6.1, provided there is no free liquid visible at the time the material is loaded or at the time the packaging or transport unit is closed. (3) A code containing the letter B refers to a special provision that applies only to bulk packaging requirements. 22 If the hazardous material is in dispersion in organic liquid, the organic liquid must have a flash point above 50 C (122 F). TABLE 2 lists . TP21 The wall thickness must not be less than 8 mm. Where the quantity of hazardous materials contained as an integral element in machinery or apparatus exceeds the limits permitted by 173.222(c)(2), and the hazardous materials meet the provisions of 173.222(c), the machinery or apparatus may be transported by aircraft only with the prior approval of the Associate Administrator. These provisions apply only to transportation in IBCs and Large Packagings. The temperature of the material at the time it is offered for transport and during transportation may not exceed 55 C (130 F). (TOY CAPS) - HANDLE CAREFULLY OR TOY CAPS - HANDLE CAREFULLY; and. TP45 Each portable tank must be made of stainless steel, except that steel other than stainless steel may be used in accordance with the provisions of 173.24b(b) of this subchapter. N77 For materials of not more than two percent active ingredients by weight, packagings need not conform to the requirements of part 178 of this subchapter, if liquid contents are absorbed in an inert material. For transportation by aircraft, a telephone report in accordance with 171.15(a) is required if a fire, violent rupture, explosion or dangerous evolution of heat (i.e., an amount of heat sufficient to be dangerous to packaging or personal safety to include charring of packaging, melting of packaging, scorching of packaging, or other evidence) occurs as a direct result of a dry battery. Multiple provisions can be listed in this column. B13 A nonspecification cargo tank motor vehicle authorized in 173.247 of this subchapter must be at least equivalent in design and in construction to a DOT 406 cargo tank or MC 306 cargo tank (if constructed before August 31, 1995), except as follows: a. Packagings equivalent to MC 306 cargo tanks are excepted from the certification, venting, and emergency flow requirements of the MC 306 specification. Note also that this exception does not apply to batteries that have been reconditioned for reuse. will bring you directly to the content. 119 This substance, when in quantities of not more than 11.5 kg (25.3 pounds), with not less than 10 percent water, by mass, also may be classed as Division 4.1, provided a negative test result is obtained when tested in accordance with test series 6(c) of the UN Manual of Tests and Criteria (IBR, see 171.7 of this subchapter). This content is from the eCFR and is authoritative but unofficial. not more than 0.1 mL/hour per 30 mL inner packaging at 20 C (68 F) produced from gradual decomposition. When Column 7 refers to a special provision for a hazardous material, the meaning and requirements of that special provision are as set forth in 172.102 of this subpart. Except when approved by the Associate Administrator, these items may only contain hazardous materials for which exceptions are referenced in Column (8) of the 172.101 Table and are provided in part 173, subparts D and G, of this subchapter. This includes hybrid electric vehicles powered by a fuel cell, an internal combustion engine, and wet, sodium or lithium batteries installed. A single packaging of a 4C2 sift-proof, natural wood box; or. subject to the Hazardous Materials Regulations must comply with all applicable requirements of Subpart F [172.500]. Non-specification bulk bins are authorized. This document is available in the following developer friendly formats: Information and documentation can be found in our These mixtures may be classified in Division 4.1 when tested in accordance with test series 6(c) of the UN Manual of Tests and Criteria (IBR, see 171.7 of this subchapter) and approved by the Associate Administrator. For single packagings, each packaging must correspond to a design type that has passed a leakproofness test at the Packing Group II level. 61 A chemical oxygen generator is spent if its means of ignition and all or a part of its chemical contents have been expended. j. The material must be loaded dry. If the air bag inflator unit satisfactorily passes the series 6(c) test, it is not necessary to repeat the test on the air bag module. TP40 The portable tank must not be transported when connected with spray application equipment. For transportation by aircraft, the provisions of 173.159(b)(2) apply. a. TP38 Each portable tank must be insulated with an insulating material so that the overall thermal conductance at 15.5 C (60 F) is no more than 1.5333 kilojoules per hour per square meter per degree Celsius (0.075 Btu per hour per square foot per degree Fahrenheit) temperature differential. Formulations not meeting these criteria must be transported under the provisions applicable to the appropriate entry in the Organic Peroxide Table in 173.225 of this subchapter. Flexible, fiberboard or wooden IBCs must be sift-proof and water-resistant or be fitted with a sift-proof and water-resistant liner. 165 These substances are susceptible to exothermic decomposition at elevated temperatures. Net weight of contents in wooden boxes, barrels or kegs may not exceed 45 kg (99 pounds). The operator of an aircraft carrying hazardous materials must do all of the following EXCEPT: A. (1) Numeric provisions. B4 MC 300, MC 301, MC 302, MC 303, MC 305, and MC 306 and DOT 406 cargo tanks are not authorized. b. 372 This entry applies to asymmetric capacitors with an energy storage capacity greater than 0.3 Wh. The rechargeable lithium ion cells can only be charged from the primary lithium metal cells; ii. For UN identification numbers 1327, 1363, 1364, 1365, 1386, 1408, 1841, 2211, 2217, 2793 and 3314, IBCs are not required to meet the IBC performance tests specified in part 178, subpart N, of this subchapter. B30 MC 312, MC 330, MC 331 and DOT 412 cargo tanks and DOT 51 portable tanks must be made of stainless steel, except that steel other than stainless steel may be used in accordance with the provisions of 173.24b(b) of this subchapter. N6 Battery fluid packaged with electric storage batteries, wet or dry, must conform to the packaging provisions of 173.159 (g) or (h) of this subchapter. The total weight of the explosive contents of the shaped charges assembled in the guns does not exceed 90.5 kg (200 pounds) per vehicle; and. 106 The recognized name of the particular explosive may be specified in addition to the type. e. When transported by highway, rail, vessel, or as cargo on an aircraft, neutron radiation detectors containing not more than 1 gram of boron trifluoride, including those with solder glass joints are not subject to any other requirements of this subchapter provided they meet the requirements in paragraph a of this special provision and are packed in accordance with paragraph b of this special provision. See also UN1942 in the 172.101 Hazardous Materials Table. When column 7 of the Hazardous Materials Table (49 CFR 172.101) includes a special provision code for an entry in the table, the requirement of that code - or codes, there may be several of them - is in addition to the general packaging requirements of 173.24 and any other applicable packaging requirements in Part 173. Packagings must be so constructed that explosion is not possible by reason of increased internal pressure. Each special provision is indicated using a numeric or alphanumeric code. 41 This material at the Packing Group II hazard criteria level may be transported in Large Packagings. Heater pipes must be of welded construction designed for a test pressure of 500 psig. During transport, it must be protected from direct sunshine and stored (or kept) in a cool and well-ventilated place, away from all sources of heat. A212 UN 2031, Nitric acid, other than red fuming, with more than 20% and less than 65% nitric acid intended for use in sterilization devices only, may be transported on passenger aircraft irrespective of the indication of forbidden in columns (9A) of the 172.101 table provided that: a. Examples of such vehicles are cars, motorcycles, trucks, locomotives, scooters, three- and four-wheeled vehicles or motorcycles, lawn tractors, self-propelled farming and construction equipment, boats, and aircraft. A19 Combination packagings consisting of outer fiber drums or plywood drums, with inner plastic packagings, are not authorized for transportation by aircraft. There must be no hazardous effects outside the package such as disruption of the package, metal fragments or a receptacle which passes through the packaging. (a) General. Special provisions contain packaging provisions, prohibitions, exceptions from requirements for particular quantities or forms of materials and requirements or prohibitions applicable to specific modes of transportation, as follows: (1) A code consisting only of numbers (for example, 11) is multi-modal in application and may apply to bulk and non-bulk packagings. N86 UN pressure receptacles made of aluminum alloy are not authorized. For all modes of transportation, a written report submitted, retained, and updated in accordance with 171.16 is required if a fire, violent rupture, explosion or dangerous evolution of heat occurs as a direct result of a dry battery or battery-powered device. With less than 25 percent but not less than 10 percent formaldehyde, must be described as UN3334, Aviation regulated liquid, n.o.s. Further, the limitations and/or additional requirements found in the special provisions of column 7 will supersede the packaging authorizations of column 8 of the Hazardous Materials Table. b. 11 The hazardous material must be packaged as either a liquid or a solid, as appropriate, depending on its physical form at 55 C (131 F) at atmospheric pressure. A35 This includes any material which is not covered by any of the other classes but which has an anesthetic, narcotic, noxious or other similar properties such that, in the event of spillage or leakage on an aircraft, extreme annoyance or discomfort could be caused to crew members so as to prevent the correct performance of assigned duties. In addition, there are over 300 numeric codes provisions. (Toy caps), 1.4S or NA0337, Toy caps, 1.4S are not subject to the subpart E (labeling) requirements of this part when offered for transportation by motor vehicle, rail freight, cargo vessel, and cargo aircraft and, notwithstanding the packing method assigned in 173.62 of this subchapter, in conformance with the following conditions: a. The examination and testing of each lighter design must be performed by a person authorized by the Associate Administrator under the provisions of subpart E of part 107 of this chapter, as specified in 173.308(a)(4). The Associate Administrator may except from the requirements of this subchapter articles, machinery, and apparatus provided: a.

Whur Gospel Spirit Travelogue, Rodney Wilson Obituary, Chevron Vice President Salary, Male To Female Before And After Hormones, Wwe 2k22 Universe Mode Draft Generator, Articles C